Installation
9
To prevent possible damage to yourNOTE: When replacing batteries it is
speakers and other components in youralways a good idea to replace both at the
audio system, it is important that ALLsame time. When the unit will not be
components, including the FL8550 andused for an extended period of time, it is
receivers are turned off and unpluggedalso a good idea to remove the batteries
from their AC power source whenso that the potential for corrosion or
installing any new component.
damage is avoided.
Connecting the FL8550 to your audioConnect the power to a non-switched AC
system is simple. Using standard RCA-wall outlet, or to the accessory outlet on
to-RCA interconnect cords, connect thethe rear of another audio device in your
left and rightFixed Audio Outputsystem and you are ready to go!
jacks ° on the rear panel to the CD
input jacks on your receiver, surround
processor or preamplifier.NOTE: When using the accessory outlet
on another product to power the FL8550
make certain that it has the ability to
If your system includes an optional,power a device that draws at least 20
external digital-to-analog converter, or watts of current in addition to the
if you are using a receiver or other pro-requirements of other devices that may
cessor that has the capability to decodebe plugged into the accessory outlets. If
PCM digital input signals, connect theyou use a Oswitched� outlet, it is impor-
Coaxial Digital Outputjack ato tant to remember that the host product
the Datastream Digital input on the
decoder. Make certain to use a coaxial-Å¢must be turned on in order for the
FL8550 to operate.
style interconnect cable, as standard
audio cables will not perform as well.
Install the two AA batteries supplied with
the FL8550Os remote by turning the remote
over so that you are holding the bottom
side up. Press lightly on the embossed
arrow on the cover, and gently slide the
cover towards you in the direction of the
arrow. Insert the batteries inside the com-
partment, being careful to follow the +
and � polarity indications at the bottom
of the compartment. Replace the cover by
placing it on the remote and sliding it
back towards the top of the remote. |
ACEC
